When you power up the rig, if the red Tx Led is flashing and you see "MCU LD" in the LCD (it may not be backlit), you should still be able to load firmware into your K3. Just click "Send All Firmware" and the MCU should start to load.
The MCU is in "boot load" status if the Red TX led is flashing. Restart the K3 Utility so that it finds the K3 again and again determines its baud rate (which will now be 38,400). Dick, K6KR -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Chris G3SJJ Sent: Thursday, September 11, 2008 1:59 PM To: [email protected] Subject: [Elecraft] Help with download Pressed the wrong button or something! Tx LED flashing but download has hung. I have switched off the PSU, switched on again and held the Power button down for 30 seconds which I think I had to do once before, but no success. Help please! Chris G3SJJ _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
