Sorted. I had Disabled Router Queries on the mHam Router but it still
didn't like it so I changed over a USB / Serial Interface and that
worked. My bad. Sorry.
Chris G3SJJ
Dick Dievendorff wrote:
When you power up the rig, if the red Tx Led is flashing and you see "MCU
LD" in the LCD (it may not be backlit), you should still be able to load
firmware into your K3. Just click "Send All Firmware" and the MCU should
start to load.
The MCU is in "boot load" status if the Red TX led is flashing.
Restart the K3 Utility so that it finds the K3 again and again determines
its baud rate (which will now be 38,400).
Dick, K6KR
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Chris G3SJJ
Sent: Thursday, September 11, 2008 1:59 PM
To: [email protected]
Subject: [Elecraft] Help with download
Pressed the wrong button or something! Tx LED flashing but download has
hung. I have switched off the PSU, switched on again and held the Power
button down for 30 seconds which I think I had to do once before, but no
success. Help please!
Chris G3SJJ
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
