> Sorted. I had Disabled Router Queries on the mHam Router but it still > didn't like it so I changed over a USB / Serial Interface and that > worked.
You must also set Radio type = None and have only one port active. 73, ... Joe, W4TV > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Chris G3SJJ > Sent: Thursday, September 11, 2008 6:21 PM > To: Dick Dievendorff > Cc: [email protected] > Subject: Re: [Elecraft] Help with download > > > Sorted. I had Disabled Router Queries on the mHam Router but it still > didn't like it so I changed over a USB / Serial Interface and that > worked. My bad. Sorry. > Chris G3SJJ > > Dick Dievendorff wrote: > > When you power up the rig, if the red Tx Led is flashing > and you see > > "MCU LD" in the LCD (it may not be backlit), you should > still be able > > to load firmware into your K3. Just click "Send All > Firmware" and the > > MCU should start to load. > > > > The MCU is in "boot load" status if the Red TX led is flashing. > > > > Restart the K3 Utility so that it finds the K3 again and again > > determines its baud rate (which will now be 38,400). > > > > Dick, K6KR > > > > > > -----Original Message----- > > From: [EMAIL PROTECTED] > > [mailto:[EMAIL PROTECTED] On Behalf Of Chris G3SJJ > > Sent: Thursday, September 11, 2008 1:59 PM > > To: [email protected] > > Subject: [Elecraft] Help with download > > > > Pressed the wrong button or something! Tx LED flashing but download > > has > > hung. I have switched off the PSU, switched on again and > held the Power > > button down for 30 seconds which I think I had to do once > before, but no > > success. Help please! > > > > Chris G3SJJ _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
