You should be able to use the AFV readings instead of the voltage
measured with a DMM across the speaker - then using those values, enter
them into the calculations in the XG2 manual for calculating MDS.
73,
Don W3FPR
Björn Mohr wrote:
On 2008-09-17 00.26, "Lyle Johnson" <[EMAIL PROTECTED]> wrote:
The K3's dBV function is a *relative* measure. It must be set to
whatever reference you wish by first using AFV. The calculation
measurement is true RMS. It is used for measuring things like MDS, AGC
slope, roofing filter attenuation and so forth.
So what's the correct procedure for measuring MDS using the internal meter
and a XG2 oscillator?
73 de Björn /SM0MDG
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.169 / Virus Database: 270.6.21/1676 - Release Date: 9/17/2008 9:33 AM
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
