Sounds like you have the other VFO on each band set to SSB. That would
change the default mode for that control to Mic Gain from CW Speed.
A single tap of A->B only copies frequency. A double tap of A->B copies
all other parameters (mode, filter etc.)
73, Eric WA6HHQ
Rick Dettinger wrote:
My K3, Serial Number 556, is not working properly in the VFO split
mode. I only work CW and when I hold split, the CW speed control
light changes to the MIC light. The transmitter will then not key.
Switching back to transceive restores the ability to key the
transmitter. This happens on all bands except 80, 40, and 30
meters. On these three bands, everything works as it should. This
might be a clue, as these are the only bands I normally use. I just
found this out today when I went on 20 meters. I usually use split
instead of RIT, as I prefer to use the larger knob. My firmware is
02.39 and 01.91. Any ideas? Did I not set up all the bands correctly?
Thanks and 73
Rick Dettinger K7MW_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
