Rick,
Does the VFO B knob change the frequency of VFO B? If it does, there is
nothing wrong with the encoder, and you should send a note to
[EMAIL PROTECTED]
If not, swap the encoder between VFO B and RIT (or VFO A and VFO B
whichever is easiest for you) - if the problem follows the encoder
position, ask for a replacement encoder.
If the problem stays with VFO B, then there is a front panel problem and
you should ask [EMAIL PROTECTED] for additional assistance.
73,
Don W3FPR
Rick and Theresa Low wrote:
(separate weekend mail sent to K3support)
I'm in the middle of "Test and Calibration", which begins on page 64 of the
Assembly manual.
Initial power Checks: satisfactory
Synthesizer Calibration: completed satisfactorily
Filter setup: made it through Filter Bandwidth Setup and Filter Center
Frequency Setup...but it appears the settings may not have been accepted...and
I've lost control of the ability to change anything using the VFO B encoder.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
