Hello Don, The encoder in the VFO B spot does not change VFO B displayed frequency (and does not change any of the menu items, either.
Thanks for the reply. 73 Rick N6CY Reston, VA -----Original Message----- >From: Don Wilhelm <[EMAIL PROTECTED]> >Sent: Sep 27, 2008 6:53 PM >To: Rick and Theresa Low <[EMAIL PROTECTED]> >Cc: [email protected] >Subject: Re: [Elecraft] Loss of VFO B encoder control > >Rick, > >Does the VFO B knob change the frequency of VFO B? If it does, there is >nothing wrong with the encoder, and you should send a note to >[EMAIL PROTECTED] > >If not, swap the encoder between VFO B and RIT (or VFO A and VFO B >whichever is easiest for you) - if the problem follows the encoder >position, ask for a replacement encoder. >If the problem stays with VFO B, then there is a front panel problem and >you should ask [EMAIL PROTECTED] for additional assistance. > >73, >Don W3FPR > >Rick and Theresa Low wrote: >> (separate weekend mail sent to K3support) >> >> I'm in the middle of "Test and Calibration", which begins on page 64 of the >> Assembly manual. >> >> Initial power Checks: satisfactory >> Synthesizer Calibration: completed satisfactorily >> Filter setup: made it through Filter Bandwidth Setup and Filter Center >> Frequency Setup...but it appears the settings may not have been >> accepted...and I've lost control of the ability to change anything using the >> VFO B encoder. >> >> _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
