Ted,
It has always worked like that. If you previously had VFO A and VFO B
showing different bands, I would think you had a display problem.
Currently even with the KRX3 installed, cross-band operation is not yet
implemented in the current firmware, but is being addressed as a planned
future firmware addition (only for those with the KRX3).
73,
Don W3FPR
wa6riv wrote:
I updated my firmware and caused a problem. I have not purchased a sub
receiver and is not installed.
When I'm in VFO A, and do a band change, VFO B follows the same band.
I can swap A=>B or B=>A, move from A to B or B to A.
But I can't have VFO A on 40 meters and VFO B on 20 meters.
The Band switch transfers both VFO's to the same band at the same time.
What have I done? Tnx Ted WA6RIV
------------------------------------------------------------------------
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.173 / Virus Database: 270.8.0/1722 - Release Date: 10/13/2008 7:50 AM
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
