Hello, Can anybody help explain clearly to me how I connect a receive converter up to my K3? I blew up my 2m receive converter hooking it up to the main 28 MHz antenna terminal today and I don't want to repeat that if I can find a replacement somewhere!
I have found the transverter settings in the config menu, and think I have those set up so I SHOULD be able to get something to work by plugging 28 MHz IF output into the transverter input, but I was unable to figure out how to make the K3 look for signal there. I also did not get any RF input when I connected the 28 MHz IF output to the RX ANT IN jack :-( There must be some mystery switch that I haven't found yet to enable these two functions. I also would appreciate it if somebody knows how to mute the K3 receiver when a separate XMTR is being used. I searched the manual but could not find it. I am trying to incorporate the K3 into my existing station, but the rats nest and maze of decades of wiring is very frightening! Any guidance would be greatly appreciated. VY 73, Lance -- Lance Collister, W7GJ (ex: WN3GPL, WA3GPL, WA1JXN, WA1JXN/C6A, ZF2OC/ZF8) P.O. Box 73 Frenchtown, MT 59834 USA QTH: DN27UB TEL: (406) 626-5728 URL: http://www.bigskyspaces.com/w7gj 2m DXCC #11/6m DXCC #815
_______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
