Lance,
you can disable TX-out by TX INHIBIT signal to be sure you are not
emitting RF. It is possible by some short pins on connector only or
you can force this together with PTT from the second RIG. Then you do
not need to go to TX TEST mode manually and you will disable TX only
when second RIG will go to TX.
But do not understand why you are not able to XMIT now... If something
strange then F/W reloading I will do as the first. But...
GL in the Contest,
73!
Lexa, ok1dst
K3/10 #727
LANCE COLLISTER napsal(a):
gd0tep wrote:
> *Hi Lance & group.*
>
>>I also would appreciate it if somebody knows how to mute the K3 receiver
> when a
>>separate XMTR is being used. I searched the manual but could not find it.
>
> Something I've done to overcome a similar problem was TXing the K3 as
> well, perhaps have it go split somewhere away from your TX frequency at
> low to zero power?
>
> Does that help?
>
> Andy
>
> http://gd0tep.com
>
G4AON suggested that I put it into TEST mode, in which case it will only
mute the
receiver when I key it up. That seems like a good solution.....but now
that it is
muted I can't get it to XMIT anymore :-( There is an awful lot to try to
figure out
on this radio, and obviously something that I should have tried to
figure out before
I went to the East Coast this week :-( Obviously with a blown up
converter I guess I
won't be on at all for the EME contest this weekend, but I hope I can
get something
lashed together so I can operate both 6m and 2m EME again for the P29
and all my
other 6m EME skeds next week! Right now, I can't even XMIT with it on 6m
anymore....
73, Lance
--
Lance Collister, W7GJ (ex: WN3GPL, WA3GPL, WA1JXN, WA1JXN/C6A, ZF2OC/ZF8)
P.O. Box 73
Frenchtown, MT 59834 USA
QTH: DN27UB
TEL: (406) 626-5728
URL: http://www.bigskyspaces.com/w7gj
2m DXCC #11/6m DXCC #815
------------------------------------------------------------------------
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
