gd0tep wrote: > *Hi Lance & group.* > >>I also would appreciate it if somebody knows how to mute the K3 receiver > when a >>separate XMTR is being used. I searched the manual but could not find it. > > Something I've done to overcome a similar problem was TXing the K3 as > well, perhaps have it go split somewhere away from your TX frequency at > low to zero power? > > Does that help? > > Andy > > http://gd0tep.com > G4AON suggested that I put it into TEST mode, in which case it will only mute the receiver when I key it up. That seems like a good solution.....but now that it is muted I can't get it to XMIT anymore :-( There is an awful lot to try to figure out on this radio, and obviously something that I should have tried to figure out before I went to the East Coast this week :-( Obviously with a blown up converter I guess I won't be on at all for the EME contest this weekend, but I hope I can get something lashed together so I can operate both 6m and 2m EME again for the P29 and all my other 6m EME skeds next week! Right now, I can't even XMIT with it on 6m anymore.... 73, Lance
-- Lance Collister, W7GJ (ex: WN3GPL, WA3GPL, WA1JXN, WA1JXN/C6A, ZF2OC/ZF8) P.O. Box 73 Frenchtown, MT 59834 USA QTH: DN27UB TEL: (406) 626-5728 URL: http://www.bigskyspaces.com/w7gj 2m DXCC #11/6m DXCC #815
_______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
