Thanks, Barry. This should be true if CONFIG: MEM 0-9 is set to BAND SEL, but I have it set to NOR. In which case, 0-9 should NOT be in the band select mode and ALL memories should be accessable with M>V ## M>V...unless of course I missed something in the updates :)
Jim Barry Simpson wrote: > > Hi Jim > > Memories 0-9 are quick memories which are accessed by the commands M-V and > then the keypad number. I have programmed each of those memories with each > band 160 thru 6 metres so that I can change bands without having to use > the > up/ down button. I have also programmed the M1 thru M4 buttons to provide > an > additional four frequencies in each band. In fact you can program VFO A > and > VFO B separately so that in fact with all of the above I have up to nine > frequencies (each with pre-programmed modes) quickly accessible for each > band. > > However I digress. To access memories 10 and upwards you simply press the > M-V command and then rotate the VFO A knob to get to the memory number you > require. To program a memory with the current VFO A frequency, mode and > selectivity you need to use the V-M command and then either press the > keypad > number to be programmed (0 thru 9) or rotate VFO A for memories 10 and > upwards to select the number you want and then press V-M again. > > I hope this helps. > > 73 > > Barry Simpson VK2BJ > > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > > :-/:-/ -- View this message in context: http://n2.nabble.com/K3-Memory-Recall---Acting-Like-Band-Select-tp2017818p2019187.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
