One thing I think would be really slick is to see a path in which someone can insert a watt meter such as the LP-100 into the chain between the output and the antenna tuner where it belongs. I really like all of the flexibility that the RX ANT path affords... Would be really neat to be able to see something like that on the way out.
~Brett (KC7OTG) On Fri, 2009-01-02 at 10:01 -0800, wayne burdick wrote: > Stewart Baker wrote: > > > The K3 output was from ANT1 using the internal ATU. The ATU was > > automatically tuned to 1:1 on all bands. > > The results I got for 2:1 VSWR are as follows:- > > > > LP-100 K3 > > 160 1.99 1.8 > > 80 1.99 1.8 > > 60 1.99 1.8 > > 40 1.95 1.8 > > 30 1.97 1.6 > > 20 1.97 1.4 > > 17 1.97 1.3 > > 15 1.96 1.2 > > 12 1.96 1.5 > > 10 1.96 1.4 > > Much of this could be attributed to the different locations of the two > bridges (see my previous email). Strays will vary from band to band. > > Also, the K3's bridge will be a little more accurate at 100 W than at > 10 W due to the bridge diode drops. I compensate for this to some > degree in firmware, and I'll review it when I get a chance. > > 73, > Wayne > N6KR > > --- > > http://www.elecraft.com > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
