Hi Dana I can think of several ways to do what you want, but they will take a little bit of building. One way would be for you to make a small relay box that would connect your 40m antennas to ANT1 and ANT2 of the KAT3 ATU. On other bands, you could have whatever other antennas you use connected to ANT1 and ANT2, but switch to the 40m antennas on 40m. The relays in the box can be controlled from the KRC2, which is the way I switch my antennas here. GL and 73 Bob N6WG
----- Original Message ----- From: "Dana Roode" <dana.ro...@gmail.com> To: <elecraft@mailman.qth.net> Sent: Tuesday, January 06, 2009 7:06 AM Subject: [Elecraft] KRC2 - More than one antenna per band? Aux outputs? > Greetings, > > Is there a way to select more than one antenna per band with the KRC2? > IE, I have a 40 meter 4 square and a dipole, can I automatically > select one when I go to 40 and still be able to select the other on > manual command? I need to do this remotely. > > Similar question, there are a few Aux outputs on the KRC2, how does > one control those remotely (that is, via the serial interface or some > other means)? I have to select directions on my 4 square, and switch > in and out a series capacitor on my 80 meter vertical for SSB. > > Dana, K6NR > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
