This is the current state of the radio :
the 6 khz filter is in FL2, the 2.7 khz filter is in FL3. ESSB is on, and set
to 4.0, complete with the '+' displaying in the right of the display when
USB/LSB is used (note that it is off during DATA modes). AM TX is set to FL2,
SSB TX is set to FL3 (it will not allow it to be set to FL2, even with ESSB
on). IN data A, I am setting the DSP to 4 khz. If the firmware is enforcing the
use of FL3 for Data A, why would this be so? With software that can do 4.0 khz
or greater waterfalls, why would we want to arbitrarily restrict the radio? For
that matter, why restrict it at all for DATA modes? If the software on the
computer would do it, why should we not be able to receive or transmit with
say, the FM filter? If there is any such restriction, I would like to have the
possibility of removing it considered. Thanks!
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
