> About to (finally) try out some RTTY/PSK31 using soundcard > AFSK A/DATA A modes. Intuitively was going to run at reduced > power being 100% duty cycle but have read in a couple of > places (not the manual..) that you can run RTTY at full power > (100w).
The K3 will handle 100W for 10 minutes in ... RTTY will be fine at full power. > Is this right and presumably it applies as well to PSK? PSK31/62/125 is a "two tone" mode and will show significant IMD at power greater than 50 to 60 watts peak (20 to 30 W average in "idle"). 73, ... Joe, W4TV > -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of GW0ETF > Sent: Tuesday, January 20, 2009 4:49 AM > To: [email protected] > Subject: [Elecraft] K3 - Tx power in digi modes > > > > About to (finally) try out some RTTY/PSK31 using soundcard > AFSK A/DATA A modes. Intuitively was going to run at reduced > power being 100% duty cycle but have read in a couple of > places (not the manual..) that you can run RTTY at full power > (100w). Is this right and presumably it applies as well to PSK? > > RYRYRY > > Stewart Rolfe, GW0ETF > -- > View this message in context: > http://n2.nabble.com/K3---Tx-power-in-digi-modes-tp2185735p218 5735.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
