4CX250B wrote:
> This may have been covered before, but I'd really like the K3 to allow
> band-specific power settings. Since there's no provision for amplifier ALC,
> it would be helpful to set the power output on a band-by-band basis. In other
> words, if an amplifier takes 40Watts drive on 40m but 60 Watts on ten meters,
> one could adjust the power output on each band once and then have the K3
> remember the settings. Solid state amps, especially, often have
> frequency-dependent gain.
Hi Jim,
Set "CONFIG:PWR SET" to "PER-BAND".
HTH,
~Iain / N6ML
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
