Does CONFIG:PWR SET to the "PER BAND" choice meet your needs? Dick, K6KR
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of 4CX250B Sent: Monday, January 26, 2009 3:55 PM To: [email protected] Subject: [Elecraft] K3 Suggestion This may have been covered before, but I'd really like the K3 to allow band-specific power settings. Since there's no provision for amplifier ALC, it would be helpful to set the power output on a band-by-band basis. In other words, if an amplifier takes 40Watts drive on 40m but 60 Watts on ten meters, one could adjust the power output on each band once and then have the K3 remember the settings. Solid state amps, especially, often have frequency-dependent gain. 73, Jim W8ZR _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
