Hi Steve, I've noticed that data mode seems to always be AFSK A after updating firmware regardless of what it was set to before the update, but I've not had it spontaneously change just by turning the rig off as you describe. (That said, I *have* had cases where the band map has changed without me explicitly changing it, but I've never been able to intentionally reproduce it. The usual change is 40m gets mapped out or 60m gets mapped in.)
Are you turning the rig off with the power button on the front panel, or by shutting off your power supply while the rig is on? Shutting off your power supply while the rig is turned on can result in some settings not being saved. 73 -- Joe KB8AP On Mar 9, 2009, at 4:23 PM, list1 wrote: > Hi All, > I just noticed something that tends to happen on my K3. I had > problems > running MT63. The finally found the problem and it was that the > radio had > changed from DATA A digital mode to AFSK A mode. Changing it back > to DATA A > fixed the problem. When I turned the radio off, waited 10 seconds, > and then > turned the radio back on the radio was still set to DATA A. > > However, I checked the mode this morning and it was back to AFSK A > again. > The frequency had not been changed. > > I don't know if it is me or the firmware. (I am betting on the > former) > > Firmware is 2.78 > > 73, > Steve, W2MY > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
