Joe, I have done many firmware upgrades and my data mode has stayed the same as it was previously set. I have mine currently set to PSK D, so there is not an exact comparison with your experience, but I really don't think it is the firmware upgrade causing it.
73, Don W3FPR Joe Planisky wrote: > Hi Steve, > > I've noticed that data mode seems to always be AFSK A after updating > firmware regardless of what it was set to before the update, but I've > not had it spontaneously change just by turning the rig off as you > describe. (That said, I *have* had cases where the band map has > changed without me explicitly changing it, but I've never been able to > intentionally reproduce it. The usual change is 40m gets mapped out > or 60m gets mapped in.) > > Are you turning the rig off with the power button on the front panel, > or by shutting off your power supply while the rig is on? Shutting > off your power supply while the rig is turned on can result in some > settings not being saved. > > 73 > -- > Joe KB8AP > > > On Mar 9, 2009, at 4:23 PM, list1 wrote: > > >> Hi All, >> I just noticed something that tends to happen on my K3. I had >> problems >> running MT63. The finally found the problem and it was that the >> radio had >> changed from DATA A digital mode to AFSK A mode. Changing it back >> to DATA A >> fixed the problem. When I turned the radio off, waited 10 seconds, >> and then >> turned the radio back on the radio was still set to DATA A. >> >> However, I checked the mode this morning and it was back to AFSK A >> again. >> The frequency had not been changed. >> >> I don't know if it is me or the firmware. (I am betting on the >> former) >> >> Firmware is 2.78 >> >> 73, >> Steve, W2MY >> >> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
