Hello, getting finally around to setting up my K3 for RTTY/PSK, ie. hooking the line in/out to the computer, I noticed that Line In doesnt work for me.
- Cables are OK (tested by plugging into MIC IN, the signal is rather loud but there) - MICSEL to LineIn, and line level have been tried up to 60 - Some time ago when I had my K3 open I had done all the mods re. audio (mainly line out and the gnd mods) . I double-checked and all seems as per spec... - Using an ohmmeter to measure into line-in yields 630 ohm which looks about right as per schematic, so I didnt short-circuit things... - I updated firmware to 3.10 Could someone please confirm that Line In does work with fw rev 3.10 ? Any further ideas ? Mario -- Mario Lorenz Internet: <[email protected]> Ham Radio: dl5...@db0erf.#thr.deu.eu The deorbiting of MIR was brought to you by radio FFH and MIRcrosoft, your specialist for controlled crashes! (local radio station, on the very day) ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
