Make sure you have set the 2.7K filter as the TX for all modes where it makes sense. (all but AM in your case it would appear)
~Brett On Sun, 2009-08-09 at 07:42 +0000, Eric Merlen wrote: > Good morning folks, > > I assembled a K3/10 + KBPF3 + AM filter (+ default 2.7Khz filter). After > synth calibration, filter setup, ref oscillator calibration I performed TX > gain calibration using Electraft K3 utility, but it fails immediately with > *ERR > TXG*. > > Filter setup is > Fil1: none > Fil2: 6.0Khz (0hz), 0db > Fil3: 2.7 (-0.85Khz), 0dB > > Any idea of what the problem could be? > Thanks > > Eric ve2shf > > > REF: > Starting 5 watt calibration > Calibrating at 1.900 MHz > IsSamplingComplete: Unexpected response "DS@@@@@>>@€€;" to "DS;" State 153 > Calibration power settled at " 0.0 W ;" > 5 watt calibration failed > Elapsed time: 7 seconds > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
