Hi Bret, Thanks for the suggestion.
I confirm I set the 2.7Khz filter as the TX filter for all modes but AM where the 6Khz filter is used. I left FIL1 slot empty as I plan to add an FM filter at some point (and more filters for CW/data) later, but according to the manual, that's fine to do so. One think worth mentioning: I had to apply significant pressure on the three transistors mounted on LPA board when I installed the lower bottom panel because the transistors raised slightly above the bottom panel level. I don't know if it is normal (ensure good thermal contact?) or if I used the wrong screws somewhere. Eric On Sun, Aug 9, 2009 at 4:33 AM, Brett Howard <[email protected]>wrote: > Make sure you have set the 2.7K filter as the TX for all modes where it > makes sense. (all but AM in your case it would appear) > > ~Brett > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
