Well just mucked around on the bands for a bit (about 40 minutes or so) with the hardware mods in place and switched it back to SPI1 and I wasn't able to get anything to behave strangely...
However in trying to recall the change from memory I did find that pressing 8 while in VCO MD changes what appears to be a tolerance settingg? The possible choices were MFG and NOR. I ended up leaving it back at NOR... Wonder how many of those little tricks are hidden about... ~Brett On Sun, 2009-08-23 at 19:14 -0700, Ron D'Eau Claire wrote: > Hi Brett. After putting in the diodes and resistors the VFO in my K3 was > unstable until I changed to SPI 2. > > Wayne thought this was normal. > > Ron AC7AC > > -----Original Message----- > Actually I believe that the signals will be plenty stable if you place > the hardware mod but don't change the frequency. However speeding > things up (using the SPI2 setting) w/o proper termination is going to > cause problems. > > ~Brett (KC7OTG) > > 73 > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
