This was mis-worded in the doc and is being corrected. It should read: "IMPORTANT: You must complete the modification as described below before enabling the vfo noise reduction menu item in version 3.24 or later. Failure to do so may result in erratic behavior of your K3."
Basically, he resistor/diode mod is only necessary if you -enable- the option in the menu (which only appears in V3.24 and later). Its perfectly OK to run 3.24 (or later) and not make that h/w mod (as long as it is not enabled in the menu.) There is no downside to making this h/w mod, even if you do not enable the menu option. 73, Eric WA6HHQ David Pratt wrote: > In a recent message, Roy Morris <[email protected]> wrote ... > >> Now that my K3s have v. 3.25 firmware, >> > ... > >> While I have access to the PCB, why not go ahead and install the VFO >> tuning noise reduction mod even though I do not experience noise during >> VFO rotation on 6, 10, and 60 meter bands. You might say "if it ain't >> broke, don't fix it". >> > > The mod notes for the VFO Tuning Noise Reduction do say, in bold type.. > > "IMPORTANT: You must complete the modification as described below > before using firmware version 3.24 or later. Failure to do so will > result in erratic behavior of your K3." > > That seems to imply that even if you don't notice to be broke, it may > be. > > 73 > -- _..._ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
