This sounds like he is not talking about the concentric knobs on the AF/RF gain pots (which have a set screw).
It sounds like the push on knobs used for the four mechanical encoders just to the left of the VFO knob. Those push on knobs fit very snugly and he may not be pushing them on all the way. 73, Eric WA6HHQ Grant Youngman wrote: > On Oct 28, 2009, at 4:13 PM, Mike wrote: > > >> My kit came with the new knobs. They don't seem to go onto the shaft >> very far. So far no breakage, but two different ones have come of >> while >> I was turning them. >> > > > Maybe just tighten them a bit more? Best way to get them really deep > on the shaft is to hit 'em with a hammer :-) (Please don't do that. > Sometimes I feel like you can't make any comment on a reflector > without an appropriate disclaimer) > > Shoot, I haven't any trouble with my original concentric knobs > (shipped on ser 2091). I didn't pull a hamstring tightening them > down, and they don't fall off either :-) > > Grant/NQ5T > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > -- _..._ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
