Sorry, but I have to meet my reading tutor now. I misread the thread. I blame it on that speed reading course I never took. :-[
I'm referring to the 4 knob set [shift,width,speed,cmp]. Mike NF4L Grant Youngman wrote: > On Oct 28, 2009, at 4:13 PM, Mike wrote: > > >> My kit came with the new knobs. They don't seem to go onto the shaft >> very far. So far no breakage, but two different ones have come of >> while >> I was turning them. >> > > > Maybe just tighten them a bit more? Best way to get them really deep > on the shaft is to hit 'em with a hammer :-) (Please don't do that. > Sometimes I feel like you can't make any comment on a reflector > without an appropriate disclaimer) > > Shoot, I haven't any trouble with my original concentric knobs > (shipped on ser 2091). I didn't pull a hamstring tightening them > down, and they don't fall off either :-) > > Grant/NQ5T > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
