Is it possible that you upgraded the firmware when you added the KXB3080? If so, the menu entries are set to default, and that means it is set to ATU CAL - check the menu.
73, Don W3FPR KD0FIN wrote: > So I just installed the KXB3080 and completed the 2 resistor "power mod" but > now my ATU doesn't seem to be working. It gives me power and SWR reading > when I use the "tune" function but I don't hear the relays clicking and it > isn't matching anything anymore. It might be unrelated but also it seems to > be very hard to find signals as well. I could hear a couple faint ones on > 80m but everything else seemed dead. The radio was working as normally as I > could tell after installing the KXB3080, and I don't think I could have > screwed up the the 2 resistors enough to cause any problems? > > ------------------------------------------------------------------------ > > > No virus found in this incoming message. > Checked by AVG - www.avg.com > Version: 9.0.709 / Virus Database: 270.14.103/2558 - Release Date: 12/11/09 > 05:06:00 > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html