Hi Juha, Are you use 2.7KHz filter? If so please check the shift freqency setting. One of my friend meet this problem on SSB mode, I checked his setting, found he did not correctly set the filter shift freqency. After set to correct value, no problem now.
73 de ba4rf,David 2010/3/29 Juha Kasari <juhakas...@gmail.com> > Help! > > I have K3 #2100. On CW power is very stable, but not on SSB. There is some > change on output power, it is not constant. > > If I tune my linear (Titan) on CW with 50 W, output is stable 1500 W. but > on > SSB with the same driving power I get only about 1200 W? If I whistle to > mic > it takes about 2-3 seconds and power rising to 1500W. Titan has peak power > meter and I have also Bird 43. > > I have tested also to 50 ohm dummy load and without linear, with and > without > tuner. Really, power is first about 80 W and then it go to 100 W very > slowly > on SSB. TXG VCE has no effect. > > Why? Is that normal behavior of K3? I have latest firmware, today loaded. I > think it is like ALC react too much and too quickly. > > 73 de Juha - oh6os > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > -- -------------------------------- All the best! David,ba4rf ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html