Not so good behavior on the contest, where is alltime tuning. juha - oh6os
ab2tc wrote: > > Hi, > > No, please, this is not a power calibration issue! A huge number of K3 > users have complained about this propensity of the SSB power to aim > "conservatively" for 50-80% of the requested peak power and then slowly, > very slowly climbing up to the requested power. Once reaching 100% it > stays there until you perform some kind of QSY operation other than just > turning the wheel. It is not a huge irritant to me, but an irritant > nonetheless. If I am in a big rush to have full power on SSB after a QSY, > I switch mode to TX data FSK D, do a quick squirt of TX and I have instant > full SSB peak power. > > AB2TC - Knut > > > Joe Subich, W4TV-4 wrote: >> >> >> >>> When I whistle to mic and tune my linear amplifier, I notice >>> that last watts going up very slowly. Without linear I tested >>> and sometimes first 80 watts out normally but from 80 to 100 >>> watts it takes about 2-3 seconds. >> >> Sounds like a power calibration issue. Double check the K3 >> wattmeter calibration, the amplifier gain calibrations and >> TXG VCE. >> >> 73, >> >> ... Joe, W4TV >> >> <snip> >> > > -- View this message in context: http://n2.nabble.com/K3-power-output-on-SSB-tp4818879p4823131.html Sent from the [K3] mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
