Quote 1: I don't know where you get 6mm from. The spacers are 19mm long, and standard PCB thickness (~1.5mm) thick. Two spacers on top of each other give 3mm. I had no problem with that part of the instructions. Note that the spacers are part of the final assembly.
Quote 2: With the parts on my kit, both the diffuser and LCD leads went through the board. However a newer batch (diffusers I think) had shorter leads. The diffuser should NOT be 10mm above the board. Quote 3: The LCD goes over the diffuser. The leads are long enough if the diffuser is installed properly. The whole arrangement of LCD, diffuser and spacers should be clear from the diagrams. The only complication that ever existed was the new batch with shorter leads. (Use of Quote 1, 2, and 3 reflect the list policy of not permitting interleaved, reply below specific question, posting.) Foxjazz wrote: > I am using the spacers 6mm and it calls for 19mm which makes no > sense to me. It says the diffuser must be 3mm above the pc board. > How can you use a 19mm spacer and get 3mm. WTF > It says leads may not protrude through the board, which is fine. I > put it on and the diffuser is 10mm above the board. > The problem I have is does the lcd go under or over the diffuser? > the leads dont' reach if it's over. and I don't understand how it > could fit under. > > -- David Woolley "we do not overly restrict the subject matter on the list, and we encourage postings on a wide range of amateur radio related topics" List Guidelines <http://www.elecraft.com/elecraft_list_guidelines.htm> ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
