Kieth, Glad to hear you have it working.
If your reception gets louder by just gently touching the top of the case, I would look for a problem in your antenna system - likely a broken shield connection in the coax. OTOH, if it takes a solid tap to change the volume, I would look for the unsoldered (or badly soldered) connection in the K1. If you are absolutely certain it does not happen on 40 and 30, then the bad connection would likely be found on the 4 band board. As far as the frequency coverage, re-do the VCO adjustment (spread/squeeze the turns of L1), and place the VFO frequency as close to 3090 kHz as possible - but not below that frequency (that condition must be satisfied *after* you tighten the nylon screw). You may be able to achieve the proper adjustment simply by moving the last turn of wire without loosening the L1 mounting hardware. 73, Don W3FPR K Price wrote: > Don, > > Thanks for your reply. Initially I had used a second receiver to align the > K1. But it appeared that my trimmers were more than 20 degrees off. So > based upon your suggestion I reset them and re-peaked. That did the trick! > I am now getting approx 5 watts out on all 4 bands!!! > > I managed a quick QSO on 40 meters last night before another station > clobbered my 4 watts. But at least I know it is working. > > I have two more issues that I need to track down. One is that when I touch > the top of the K1 case that the volume gets louder on 20 and 17 meters. No > change in volume on 30 and 40 meters. > > The other is that my receive range is lower than I want across the 4 bands. > 40: 6.984 - 7.084 > 30: 10.078 - 10.179 > 20: 13.978 - 14.078 > 17: 18.028 - 18.128 > Is there any way to shift it? > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
