Didn't look at your offer recently, but the last time (few years back) were all your offers out of the intended price range :). Oh, wait, USD has also fallen by a great degree since then! So technically you have to be cheaper now. But actually having 1x1 inch board that plugs to the motor controller, together with the RJ-45 socker would be nice. Suggested price about $19 each. Also a PC multi-ethernet board (Realtek 8139 class) with 4 or 5-ports or so would be lovely. You just plug your whole CNC to the computer with off the shelf cabling :D.
That would be a great advantage. On 3/30/08, Jon Elson <[EMAIL PROTECTED]> wrote: > Mario. wrote: > > Okay, if you can do turnaround of at least 100 thousand output hardware > > changes per second, I'm in. Quadrature outputs. > > Well, of course, all my interfaces do a conservative 300,000 > quadrature counts/sec on all axes. I have run this up to 5000 > servo cycles/sec, too, and should be easily able to do 10K with > a faster CPU. The universal stepper controller will output > 300,000+ steps/second per axis, too. This is all while handling > auxilliary digital I/O, too. > > > Jon > > ------------------------------------------------------------------------- > Check out the new SourceForge.net Marketplace. > It's the best place to buy or sell services for > just about anything Open Source. > http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace > _______________________________________________ > Emc-developers mailing list > Emc-developers@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-developers > ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers
