Hi Chris, > See thats a bit of the problem. I didn't add a page to configure the > two extra > ports. It just helps you set the address and the type (in/out) and > connected > signals to them. Later when time allowed the setup pages could be added.
Is there any way to re-use the existing port setup pages? Just keep track of which port they refer to. > I wasn't offended so much as annoyed by the tact on/tact off comment > to me it implied I was being tactless or stupid with my explanation > where I was just trying to explain my idea. Maybe I was over sensitive. I think John meant he was being tactless, rather than you. > Anyways I'm convinced now. I will remove parport2 and 3 signal name > generating code. How about simply adding a bunch of comments to the hal file, such as: #This port exposes the following pins for your use #parport.0.pin-02-out #parport.0.pin-03-out #parport.0.pin-13-in and so on... Dunno which hal file the comments should go in though. That would be handy as I can't always remember which pins are input and which are output. You can change the comments to suit the port setup (I/O or all input). Les ------------------------------------------------------------------------------ _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
