Michael, Michael, Charles, Jan, John, Lars, etc. I tried to keep up with the flurry of emails back in April/May but it was, shall I say, a stream-of-consciousness conversation---not easily read by a nonparticipant.
Perhaps the most telling snippet for me was > So I have the itch that we are not going to find the issue by gdb etc. but > only by getting learned on the issue of > 1. rtai interfaces > 2. rt_preempt interfaces > and how to go from the one to the other. Being expert in neither, it seemed better to wait until the dust settled. Sill I have a non-machine tool application in mind for a BeatleBoard or similar that could be fun to try using the guts of LinuxCNC. I could probably get by without any real-time considerations at all so it's no loss if latency is high. I looked through miniemc2 (Xenomi-based) and it has some very clever bits but I'd rather stick to a more mainstream distribution I understand relatively better. After several months of inactivity, the Wiki Page http://wiki.linuxcnc.org/cgi-bin/wiki.pl?Debian_Wheezy_Linux-Rt_Compile_LinuxCNC suddenly got updated a few days ago. Is that the place for a tyro to start? Regards, Kent ------------------------------------------------------------------------------ Live Security Virtual Conference Exclusive live event will cover all the ways today's security and threat landscape has changed and how IT managers can respond. Discussions will include endpoint security, mobile security and the latest in malware threats. http://www.accelacomm.com/jaw/sfrnl04242012/114/50122263/ _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
