-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 On 12/16/2012 2:09 PM, Anders Wallin wrote: >>>> with the hostmot2-firmware-3x20-1 deb package installed from >>>>> www.linuxcnc.org and trying 3x20-small.ini I now get >>>>> http://pastebin.ca/2293883 >> >> Also is it possible you have the 6I68 jumpered to auto load a >> EEPROM config? This might cause that error > > On the 6i68, I have now moved jumper W7 to the Down-position. Is > that the correct position for use with linuxcnc/hostmot2? > > However I see the same output as before (below).
What is the status of the LEDs when you power on the board? Do any of the LEDs change when you try to run linuxcnc and load the driver? - -- Charles Steinkuehler char...@steinkuehler.net -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.11 (MingW32) Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org/ iEYEARECAAYFAlDOLcsACgkQLywbqEHdNFzbZQCg5lkL9AKx9G0nICVaMnnDfNLM mrcAnjNdyk9mYlqkldt2SLBGN5YIyfkV =vlgl -----END PGP SIGNATURE----- ------------------------------------------------------------------------------ LogMeIn Rescue: Anywhere, Anytime Remote support for IT. Free Trial Remotely access PCs and mobile devices and provide instant support Improve your efficiency, and focus on delivering more value-add services Discover what IT Professionals Know. Rescue delivers http://p.sf.net/sfu/logmein_12329d2d _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers
