On Monday 10 August 2015 18:15:42 andy pugh wrote: > On 10 August 2015 at 21:26, Gene Heskett <[email protected]> wrote: > > To be specific, G92.1 is not clearing #5061, the g54 X offset. > > Possibly not clearing #5062 or #5063, all of which I use to > > calibrate the machine > > Why do you think that it should? > > The Docs say: > > G92.1 - reset axis offsets to zero and set parameters 5211 - 5219 to > zero. > And I can't read. Duh.
> G92.2 - reset axis offsets to zero. > This is 'touch offs' only? > If you want to reset G54 to Zero the code is: > > G10 L2 P1 X0 Y0 Z0 I'll do that, after homing it all, then relocate my jog doohicky so I can drive close to it, then find it with the G38.2's. That repeatability is the general idea of all this. Thanks Andy. > Again, from the docs: > > G10 L2 P- <axes R-> > > P - coordinate system (0-9) > > R - rotation about the Z axis > > G10 L2 offsets the origin of the axes in the coordinate system > specified to the value of the axis word. The offset is from the > machine origin established during homing. The offset value will > replace any current offsets in effect for the coordinate system > specified. Axis words not used will not be changed. > > Program P0 to P9 to specify which coordinate system to change. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
