On Monday 10 August 2015 19:52:51 andy pugh wrote: > On 11 August 2015 at 00:10, Gene Heskett <[email protected]> wrote: > >> G92.2 - reset axis offsets to zero. > > > > This is 'touch offs' only? > > No, it is _only_ the G92 offset. (Which you might well not be using)
I think I see. The previous msg was the magic spell though, and I now have that 20 lines of code doing as it is supposed to. And I have relocated the x offset from the jig, to the left edge of the guage blocks on the jig, but haven't recalibrated the Y offset just yet. Thats tomorrows project, while I am mulling whether or not I make the jig, either air driven to bring it in or out, or, if I can figure out how to drive a cdroms tray motor to flip it down or up electrically. So I'm going to go rooting around in the fleabay midden heap for a suitable 12 volt air valve and a mini air cylinder. I have 80 or so psi in the garage, so a 1/4" double action cylinder, with a 12 volt driven spool valve seems like the simplest way to automate it. Thank you Andy. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
