If your setting a G92 offset in the program from an arbitrary position the back plot will not be where you run.
JT On 10/1/2015 5:34 PM, Gene Heskett wrote: > Greetings all; > > This g-code to carve the joints in a blanket chest, got somewhat > refactored over the last couple of months as I tried to move the math > heavy stuff out of the subroutines in favor of doing some of it in the > initilazation phase, setting vars that the subroutines can use. And I am > not done just yet, there are still some math ops > > But in the process, the backplot has gotten a little funkity, drawing its > red lines during the program's execution at about the equ of the tool #1 > radius, (0.125") down and left of the original wireframe drawing. > > Is there a known programming no-no I need to expunge? > > Thanks all; > > Cheers, Gene > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-developers mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-developers ------------------------------------------------------------------------------ _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
