On Oct 2 2015 7:39 PM, Gene Heskett wrote:
>
> Now if I could just find a "dust deputy" sized for a
> shop-vac "bucket-max". I could probably kill both birds by Sunday
> evening. :)  Too bad I can't buy clear 4" sewer pipe, I'd try to make 
> it
> but i'd have to be able to see it working so I could fine tune the
> design. I figure a 4" pvc section a foot tall, sitting on a floor 
> flange
> screwed/glued to the lid for a 5 gallon bucket, with a 1.25" pvc pipe
> glued into the center of a 4" end cap & sticking down about 6" into 
> the
> 4" section, with a side port for a 1.25" input from the machine 
> pickup,
> 3" above the end of the suction pipe which should swirl the air and 
> dust
> enough to swirl the dust to the outside wall where it can spiral down
> into the bucket, while the relatively clean air in the center is 
> sucked
> back out the top by the vacuum.  I think I see another shopping trip 
> in
> my future tomorrow. Buckets I have, need 2. one to hold the other so 
> its
> easily removed tp dump it.  A bucket lid, a floor flange and end cap 
> and
> a few feet of sink drain tail ought to at least get me started.  And 
> it
> sounds like fun if it stretches the life of a $30 HEPA filter in the
> bucket-max.
>
> These things have a pretty decent vacuum, and can suck the sides of a 
> std
> $3 5 gallon utility bucket in 2 or 3 inches!
>
> Cheers, Gene Heskett

Are you talking about these:

http://www.acehardware.com/product/index.jsp?productId=51625696

http://www.lowes.com/pd_49940-20097-6004511_0__?productId=3160385

I am also assuming that you are wanting to integrate the vacume into 
the seperator, otherwise I do not see why having two seperate buckets 
and the piping between them is a problem.  Just make an extension on the 
top of the seperator and you should be able to add the motor on top.


------------------------------------------------------------------------------
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers

Reply via email to