On 10/03/2015 10:51 AM, Sebastian Kuzminsky wrote: > On 10/03/2015 10:21 AM, Niemand Sonst wrote: >> Hallo, please do the following: >> >> start sim axis and halshow, to whatch: >> >> - motion.toolofset.z >> - iocontrol.0.tool-number >> >> Home the machine and go to mdi tab, execute the following commands: >> >> T3 M6 >> G43 >> >> OK, hal stuff is fine, now.. >> >> M61Q0 >> >> No hal pin changed! > > I see this too (in 2.6.10). The bottom line of Axis changed from "Tool > 3, offset 1.234, diameter 5" to "No tool", but the > iocontrol.0.tool-number pin did not change. That's a bug for sure. M61 > is probably one of our less-tested codes...
Norbert, can you try the 2.6-m61-bug branch? I think i have it fixed. -- Sebastian Kuzminsky ------------------------------------------------------------------------------ _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers
