On 16/4/17 9:17 am, Gene Heskett wrote: > On Saturday 15 April 2017 06:29:22 Phillip Carter wrote: > >> I have just noticed in sim/axis/gantry that joint 3 does not jog with >> the leftbracket/rightbracket keyboard keys but does with the >> minus/equals keyboard keys. Is this the correct behaviour? > I also, for lack of anything better to do, rigged up my chop saw and > sawed off a couple hunks on 1.5" thick alu to make a new set of bearing > pushers to fit the larger OD of the correct bearing. Fired up > linuxcnc -l, (this after an early morning update of LinuxCNC-2.8-pre to > LINUXCNC - 2.8.0-pre1-2988-ge9f9469) x and z are still swapped at the > keyboard yet before being homed. Hit ctl+home, and it homed to the > correct places, and in the correct directions and homeing order. Tapped > the uparrow, then downarrow, and z moves left-right. Tapped the left > and right arrows, and x moves in and out. Switch to MDI, and its now > scrambled as well, as in G0X moves Z and G0Z moves X. So it appears > Phillips commit made the keyboard scramble apply to MDI too, which means > it cannot run code I ran on it just 2 days ago. > > Help! I do not have another functioning lathe now. > > Can you back out Phillips commit and retrigger the buildbot? It at least > ran correctly after being homed, and I could use it, once it had been > homed. > > Thanks guys. > > Cheers, Gene Heskett
I have just checked again with both sim/axis/lathe and sim/axis/historical_lathe. Keyboard jogging before and after homing works as it should: left/right arrows move Z and up/down arrows move X mdi moves are also moving correctly -- Cheers, Phill ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers
