On 25 June 2018 at 17:07, Jon Elson <el...@pico-systems.com> wrote: > On 2.8.0~pre1 (I think I get this on 2.7.14 also) any config that accesses > the parallel port produces > an error message on the Axis screen:
Using the hal_parport driver or using the ppmc driver? I wrestled with this a bit with the hm2_7i43 driver, where allowing the driver to use default port addresses meant that it reported not finding the defaults. (I just looked back at that, I wasn't clear in in my mind if I had also changed hal_parport) -- atp "A motorcycle is a bicycle with a pandemonium attachment and is designed for the especial use of mechanical geniuses, daredevils and lunatics." — George Fitch, Atlanta Constitution Newspaper, 1916 ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers
