On 06/25/2018 12:57 PM, andy pugh wrote:
On 25 June 2018 at 17:07, Jon Elson <el...@pico-systems.com> wrote:
On 2.8.0~pre1 (I think I get this on 2.7.14 also) any config that accesses
the parallel port produces
an error message on the Axis screen:
Using the hal_parport driver or using the ppmc driver?
It does NOT seem to matter! I tried a
by_interfaces/parport/stepper config and got the same error.
Jon
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-developers mailing list
Emc-developers@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-developers
