Can somebody tell me what Europe's concern is with the LED's. I understand
the hazards of laser's, wavelength, power, durations et al but I don't know
what Europe is trying to protect. 
If this was just recently discussed please forgive the transgression. I have
been sitting in those flying horizontal aluminum tubes for the last week and
have been unable to actually read any of these e-mails. Certainly, you can
respond to me directly rather than the list.
Thanks
Gary

                -----Original Message-----
                From:   [email protected] [mailto:[email protected]]
                Sent:   Wednesday, December 08, 1999 5:26 AM
                To:     [email protected]
                Subject:        RE: Products with high power LEDs


                > Assume a business product with a high power LED for use in
the EU and that
                > it operates at 230V. It will be subject to the Low Voltage
Directive, so
                > EN60950 and EN60825-1 would apply. Now assume a similar
product but it
                > operates at 24V. The LVD would not apply in this case.
What are the legal
                > compliance requirements for the LED output?
                >

                The Low Voltage Directive is definitely applicable for the
230V configuration.
                A 24V device is SELV, and has no potential for electric
shock.  If its input
                power is limited to under 100VA, it does not require a fire
enclosure per
                EN 60950.  So, the only major safety issue remaining is
possible exposure to
                the laser under fault conditions.

                EN 60825-1 (as I recall) has nothing to do with the voltage
required to power
                the host equipment.  So it applies in either case.

                George Alspaugh
                Lexmark International



                ---------
                This message is coming from the emc-pstc discussion list.
                To cancel your subscription, send mail to [email protected]
                with the single line: "unsubscribe emc-pstc" (without the
                quotes).  For help, send mail to [email protected],
                [email protected], [email protected], or
                [email protected] (the list administrators).
                

---------
This message is coming from the emc-pstc discussion list.
To cancel your subscription, send mail to [email protected]
with the single line: "unsubscribe emc-pstc" (without the
quotes).  For help, send mail to [email protected],
[email protected], [email protected], or
[email protected] (the list administrators).

Reply via email to