Hi EMC-PSTC group,
A team within my company is currently designing a amplifier speaker
unit.
Due to the current drawn is high and heat are dissipated.
Therefore the encloseure need some ventilation hole.
Unfortunately, till the very late stage of the design cycle, they found
out if this ventilation hole was blocked, it will cause the plastic
enclosure to melt.
A question was asked,
Is there a safety label/logo that we can affixed onto the plastic
enclosure so that to tell user not to block this enclosure?
(Or not to place it in a area where the ventilation will be blocked.)
I've never seen such label or logo before.
Has anyone out there seen such type of label/logo?
Any advice from the group would be much appreciated.
Regards
Koh
-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.
To cancel your subscription, send mail to:
[email protected]
with the single line:
unsubscribe emc-pstc
For help, send mail to the list administrators:
Jim Bacher: [email protected]
Michael Garretson: [email protected]
For policy questions, send mail to:
Richard Nute: [email protected]
