Hello All... I've attached ISTA's list of test labs (listed by state) for your reference.
Enjoy! George -----Original Message----- From: Matthew Meehan [mailto:[email protected]] Sent: Thursday, September 28, 2000 8:43 PM To: [email protected] Subject: RE: Vibration and Shock Testing Rick, Try the IEC 60068 series. You'll need part 1 (IEC 60068-1) and an appropriate part 2. Warning! May cause drowsiness. Do not operate heavy machinery while reading. IEC 60068-2-47 (1999-10) Environmental testing - Part 2-47: Test methods - Mounting of components, equipment and other articles for vibration, impact and similar dynamic tests IEC 60068-2-50 (1983-01) Environmental testing. Part 2: Tests. Tests Z/AFc: Combined cold/vibration (sinusoidal) tests for both heat-dissipating and non-heat-dissipating specimens IEC 60068-2-51 (1983-01) Environmental testing. Part 2: Tests. Tests Z/BFc: Combined dry heat/vibration (sinusoidal) tests for both heat-dissipating and non-heat-dissipating specimens IEC 60068-2-53 (1984-12) Environmental testing. Part 2: Tests. Guidance to Tests Z/AFc and Z/BFc: Combined temperature (cold and dry heat) and vibration (sinusoidal) tests For more information you might want to contact a company that performs HALT (Highly Accelerated Life Test) and/or HASS (Highly Accelerated Stress Screen). They should be able to advise you about industry standards and make recommendations regarding your products. Regards, Matt > This may not be the correct group to ask environmental questions, but I > thought it was a good place to start considering so many in the group wear > different hats or have past experience. In an effort to understand > principles of shock and vibration compliance, I have searched companies > like HP, Compaq and CISCO only to find if vibration and shock are called > out it is not even the same within the same company. > > The task is to define the correct vibration and shock testing for > electronic equipment, considering operational, non-operational and > transportation will have different levels. > > Are there accepted existing standard like CISPR 22 and IEC 60950 for > vibration, shock or other environmental parameters? > > Is there a similar group to this one that deals with environmental testing > and compliance? > > Thank you in advance for time on this matter. > > Rick Linford > [email protected] > > > > > > ------------------------------------------- > This message is from the IEEE EMC Society Product Safety > Technical Committee emc-pstc discussion list. > > To cancel your subscription, send mail to: > [email protected] > with the single line: > unsubscribe emc-pstc > > For help, send mail to the list administrators: > Jim Bacher: [email protected] > Michael Garretson: [email protected] > > For policy questions, send mail to: > Richard Nute: [email protected] > > > ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Jim Bacher: [email protected] Michael Garretson: [email protected] For policy questions, send mail to: Richard Nute: [email protected]
ISTA_labs.pdf
Description: Binary data
