Does anyone have a link to a copy of the "Blue Guide" mentioned by Tony below?
Jim Allan Senior Compliance Engineer Milgo Solutions Inc. E-mail [email protected] > -----Original Message----- > From: Tony Reynolds [SMTP:[email protected]] > Sent: Tuesday, May 23, 2000 10:56 AM > To: [email protected]; [email protected]; > [email protected] > Subject: Re: Fwd:R&TTE directive > > > Kim, > > According to the information I have on the R&TTE Directive (99/5/EC) > the following applies to the Declaration of Conformity. > > 'There is ONE Declaration of Conformity. It is held by the > manufacturer with the technical file for the product. The standard > EN45014 is an accepted model for the DoC, referred to in the Blue > Guide*, therefore manufacturers would seem to have no good reason not > > to use this model. The DoC is signed by the manufacturer, and is > expected to be in the language used by the manufacturer (and > understood by the signatory). A COPY of the DoC (in its original > language) must accompany every product.' > > *This is a guide to the implementation of Directives based on the New > > Approach and Global Approach (EC Doc Certif 98/1) also known as the > 'Blue Guide'. > > This information was on a DTI FAQ paper recently distributed at a > TAPC > meeting. > > I hope this helps. > > Kind Regards > > Tony Reynolds > Principal Compliance Engineer > Pitney Bowes Ltd > The Pinnacles > Harlow > Essex. CM19 5BD > UK > > Tel +44 (0) 1279 449479 > Fax +44 (0) 1279 449118 > e-mail: [email protected] > > > ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Jim Bacher: [email protected] Michael Garretson: [email protected] For policy questions, send mail to: Richard Nute: [email protected]
