Dear all, I have a doubt concerning IEC60335-1, paragraph 7.8, which is reproduced below:
7.8 Except for TYPE Z ATTACHMENT, terminals used for connection to the supply mains shall be indicated as follows: terminals intended exclusively for the neutral conductor shall be indicated by the letter N; protective earthing terminals shall be indicated by the IEC 417 Protective Earth Symbol. Question: Is it possible to have two protective earth symbols in the same appliance? Reason: Part where the symbol is stamped is common to two product models. Due to design constraints, the location where the protective earth symbol is fastened cannot be the same in both products. Thanks in advance for any input. Rgds, Luiz Claudio Bonilla de Araujo Joinville - BRAZIL _________________________________________________________ Voce quer um iGMail protegido contra vírus e spams? Clique aqui: http://www.igmailseguro.ig.com.br ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://ieeepstc.mindcruiser.com/ Click on "browse" and then "emc-pstc mailing list"
