I have seen some responses for generic audio amps. The Solar Amp you used was built for a special purpose - to drive a signal into a 2 Ohm load. With any of these power amps, you should check it has the ability to drive a clean signal at the necessary power level into whatever load impedance you need. I am on location, not near a copy of DO-160 and am not familiar with that part so I can't say if the ability to drive a standard 4 or 8 Ohm load is sufficient, or if you need a huskier device.
on 7/19/02 10:24 AM, [email protected] at [email protected] wrote: > > Hello group, > I was hoping that someone could suggest a vendor/model number for an > 100 > W audio amplifier for use performing DO-160D, change 2, section 18 audio > susceptibility testing. I am currently using an old Solar 6552-1A, but > sometimes it can't provide the pre-calibrated power (100W) into the EUT. > It could also be used for 461E CS101 testing. > > Thanks in advance, > Susan Beard > > > > ------------------------------------------- > This message is from the IEEE EMC Society Product Safety > Technical Committee emc-pstc discussion list. > > Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ > > To cancel your subscription, send mail to: > [email protected] > with the single line: > unsubscribe emc-pstc > > For help, send mail to the list administrators: > Ron Pickard: [email protected] > Dave Heald: [email protected] > > For policy questions, send mail to: > Richard Nute: [email protected] > Jim Bacher: [email protected] > > All emc-pstc postings are archived and searchable on the web at: > http://ieeepstc.mindcruiser.com/ > Click on "browse" and then "emc-pstc mailing list" > -- Ken Javor EMC Compliance Huntsville, Alabama 256/650-5261 ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://ieeepstc.mindcruiser.com/ Click on "browse" and then "emc-pstc mailing list"
